1. Start runing about 10 minutes unload,it must stop instantly to check if find abnormal problems.It would operation as the following steps if all electric and every component good condition.
2. Open the blade cover,sent the reinforce rebar to the feed wheel to place what length you want.
3. Adjust the back gauge disk close to rebar. Notice:Subject to rebar could close to the fixed blade in parallel,using the wrench to fasten the nuts on it.
4. Adjust the block rod part close to rebar. Notice:Subject to rebar could close to the fixed blade in parallel,using the wrench to fasten the nuts on it.
5. Put down cutting blade cover,use the foot pedal or manual clutch to finish cutting rebar.
6. Straightening screw rebar cutter only could one rebar one time,it would tap the screw directly after cut.
7. Cutting work done,set off the power.
FAQ
Q1: Are you trading company or manufacturer?
A: We have no agent or dealers, so the price that we provided is factory price.
About quality guarantee:The price that we provided is the lowest price,we have no profit to support over sea service.
If there is some question with your machine, we will adopt DHL, express new parts to you in 3 days,and our technologist will guide you or your technologist how to repair it. We provide parts for free in 12 months, not include the freight fee.
Q2: XXX company's price is cheaper than you, I want the cheap one.
A: Quality is more important than price. They will not sale the machine with no profit. Excessive low price means inferior parts and unconcernedly assemble. Our parts all purchased by our professional buyer, they have plenty experience to choose good parts in good price. The education background of our workers are junior college or higher than this, plenty of assemble experience. We have professional quality inspector, before our machine out of our factory, we test every machine strictly.
